The Repipe Lining System is a user friendly spray lining system. As a cost-effective and long-lasting alternative to pipe replacement, the Repipe Lining System allows for the rehabilitation of old cast iron, pvc, and clay waste and drainage pipes. This is accomplished by means of spraying a polyurea coating over the interior surface of a cleaned and prepped pipe. The material dries/cures quickly, resulting in minimal water service interruption.
Repipe Lining System
Description
Repipe Lining Systems for spray relining of shafts and pipes in the dimensions Ø 35 – 150 mm.
The entire system consists of a material and pump unit with a built in PLC control, a compact hydraulic pump station, a 45 m isolated main hose, a hose reel for the main hose, an electric, motor driven forwarder/retractor, a hot air fan, a mixing manifold and a control unit with a touch panel.
The system’s two pumps are driven by the compact hydraulic pump. The speed of the pumps and thereby the amount of material being pumped through the system is controlled by the PLC control unit and can be adjusted manually by the operator on the touch panel at any given time.
To ensure optimal reliability, the PLC monitors the mix ratio of the material, the temperature of the material and the material level in the tanks. The system is also equipped with a fully automatic self cleaning cycle increasing the reliability and the life expectancy of the system’s components.
Dancutter USA hosts a 2-3 day mandatory training course for all operators of the spray system at our Florida headquarters.
We recommend using a compressor with integrated filter and dryer so only dry and clean air is used with the spray system and the fresh air equipment.
For a detailed quote on the Repipe Lining System, please inquire here.
Additional information
| Working Area (Pipe Diameter): | 1.5" – 6" in. / 35 – 150 mm |
|---|---|
| Main Hose Length: | 45 m / 147 ft. |
| Nature of Polymer: | Polyurethane/Polyurea |
| # of Polymer Components: | 2 |
| Polymer Density: | 1:3 |
| Flash Point: | A: 248° C, 478° F |
| Bonding: | Steel with no primer: 9 Mpa |
| Service Temperature: | In air: (-140° F -+ 284° F) (-40° C -+ 140° C) |
| Shrinkage: | 0% |
| Tensile Strength: | 20 Mpa |
| Elasticity: | 50% |
| Shore A: | A 95 |
| Pot Life: | 20 min |
| Compression Strength: | 110 Mpa |
| Permeability to Water: | Impermeable |
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.